MANUFACTURING OF THREADED PRODUCTS FROM ALUMINUM ALLOY BY THE METHOD OF COLD PRESSING

Authors

  • Valijonov Behruzbek Bakhrom ogli Author

Keywords:

The purpose of this work is to demonstrate an alternative method for manufacturing threaded products. The advantages of this method compared to conventional methods are high productivity, quality, and improved strength characteristics. The main objective of the work is to demonstrate the possibility of obtaining threaded products with increased strength. As the final product, an M4 threaded stud shown in Figure 1 was selected.

Abstract

The process of cold direct pressing is a forming process carried out using a deformation tool such as a die or mold. The die or mold consists of two main parts — a punch and a matrix. The punch is attached to the ram of a hydraulic press, and due to its pressure the configuration of the product changes through deformation. The matrix serves as the stationary part of the mold, acting as the base for the deformation process of the product. The required pressure is created by the hydraulic press through its hydraulic system.

References

1. Shevakin Yu.F., Shaikevich V.S. Metal Forming. — Moscow: Metallurgy

Publishing House, 1972. — 208 p.

2. Miropolsky Yu.A., Lugovoy E.L. Thread and Profile Rolling. — Moscow:

Mashinostroenie Publishing House, 1976. — 173 p.

3. Krasilnikov L.A., Lysenko A.G. Wire Drawing and Fastener Production. —

Moscow: Metallurgy Publishing House, 1987. — 276 p.

Published

2026-05-20